Recording controller data into Sequoia?

18 Jun 2006, 20:15

Greetings,
I also posted this in the Samp forum in case it's something on that end.

Any ideas?

Here's what I'm having difficulty with:

I trigger my Vsynth with a Keystation, and record the notes to the track no problem
Input= Keystation 88
Output= Midisport 8x8 Port 2 (to Vsynth)

Plays back fine. However, I can't get any of my "tweaks" on the track. I have selected the "record automation upon recording and playing" (or something like that), and it's set up to record from the Synth as far as I know.

Input= Midisport 8x8 Port 2 (in order to record controller data from synth)
Output= Midisport 8x8 Port 2

Channels are set to "all".

I've set TX to the RX channel, local control "on".

I seem to remember having similiar issues w/ my JP8080, but that's been a long time.......

Thanks,
CAA

Re: Recording controller data into Sequoia?

18 Jun 2006, 20:47

No specific answer.

Are you sure you're not filtering (or not recording filtering) the required sys x or controller data at the sequencer end?

If you edit the track, can you see the controller/sys x data recorded OK? (If so maybe there is an output filter).

[I use Cubase SX and there are filters for all 3 of these (in, thru and out).]

That should help to narrow it down anyway.

Re: Recording controller data into Sequoia?

18 Jun 2006, 20:49

I'll check on that--anything is possible since I'm not that familiar w/ the host yet.
At any rate, I need a refresher, so all input appreciated.
CAA