Fantom-S and Fantom-X

Control Changes no.95 and above

Control Changes no.95 and above

2 Mar 2006, 16:35
I've tried searching for the answer to this but couldn't find it so I'm sorry if this has already been covered elsewhere.

I have a novation ks rack synth which I control from my Fantom X7. The Novation receives control changes 0-127 for various different parameters but I can't find any cc's of greater than 95 (phaser) in the Fantom!

I've looked it up in the manual in midi implementation and it appears to show that the fantom can only transmit cc0 to cc95. Is there any way around this? Why would they omit the last few (I realise they are rarely used, but you'd think...)

Any help would be much appreciated.

Padraig

Re: Control Changes no.95 and above

2 Mar 2006, 17:19
Hi Padraig,

Controllers 120 and above are special and a lot of midi equipment won't treat them as just another controller but as preassigned switches - omni mode, mono/poly, all sounds off etc. In fact, most CC numbers have an assigned purpose so you can't really expect 127 freely available CC's to do as you wish. I think its fine that Roland let you assign a whopping 95 of them...

These young midi controllers want to break down all the rules which the older generation set up ... er, am I raving on now?

B

Re: Control Changes no.95 and above

2 Mar 2006, 17:37
Thanks for your response.

I realise that controllers 120 and above are specific switches, but what about 96-120 (most of which are undefined in general midi terms).

I agree that 95ccs is a lot to play with - but is there any way that I can assign 20 of them to transmit at higher cc numbers (you can tell I don't know much about this).

For example - the synth's filter frequency is controlled on cc105 - is there any way I can get the Fantom to transmit that?

Thanks again for your response - I wish they'd just assigned the filter to cc 80 or something :-)

P

Re: Control Changes no.95 and above

2 Mar 2006, 17:53
Controllers 96 to 119 do indeed have predefined uses, RPN parameters which Roland could feel were special. As I said, almost everything already has an official purpose.

Sorry, I don't think there's anything you can do to create controllers above 95. I agree that Roland could easily let you have all 127 controllers - if you want to break the rules then Roland shouldn't stop you.

You might need a small midi controller just to get those CC's on a few knobs.

B

Re: Control Changes no.95 and above

2 Mar 2006, 18:27
Fair enough - not ideal, but what is this fault compared with the musicality and power of the Fantom X :o)

Thank you very much for your help LivePsy.

(on an completely unrelated note but while I'm thinking of Fantom positive points - starting to learn a thing or two about subtractive synthesis has really given me ideas about the potential of the solo synth, it amazes me how much is hidden within...)

Solosynth madness

2 Mar 2006, 18:40
Have you tried to play a tune with that thing? They stick slow and deep vibrato on there for a good reason... very hard to hit a pitch reliably.

The synthesis engine of the fantoms is very complex, Artemiy's patches demonstrate that very well. The first attempts of your own patches always suck, but stick with it.

Cheers,
B

← Back to Fantom-S and Fantom-X