FA-06 / FA-07 / FA-08

Sequencer resetting to bar 1 after editing workarounds?

Sequencer resetting to bar 1 after editing workarounds?

8 Sep 2018, 06:20
Hi, just got an Fa07 and loving it, but the annoying sequencer behaviour after doing a track edit is a little off putting, has anyone found a workaround preventing this behaviour after editing?

Re: Sequencer resetting to bar 1 after editing workarounds?

8 Sep 2018, 13:57
It's very annoying. The only workaround I know is to set a loop point to start where you're editing, then after executing a TRACK MODIFY function, go into record, don't play anything, then stop, and you'll be back where you were. There's a post or two about this idiotic feature somewhere on here if you have a look around.

Best,

CDA.

Re: Sequencer resetting to bar 1 after editing workarounds?

9 Sep 2018, 04:43
If you are in microscope edit mode, using cursor left key instead of exit key, the sequencer will stay at the current bar.

Re: Sequencer resetting to bar 1 after editing workarounds?

9 Sep 2018, 16:01
Thanks Benny will also try this, you know, I love Roland kit but I am always astounded that not at one point during testing the sequencer software someone didn't erase some measures then think...hang on? whats happening here lol.

← Back to FA-06 / FA-07 / FA-08