vkinetic wrote:I intend to connect my FA 06 to a mixer via balanced cables (TRS to XLR). However the mixer has phantom power ON which powers some DI boxes. Will that phantom power damage my FA 06?
Thanks for any help
No. Phantom power is only used when it is "called for" by the device.
For example, many mixing consoles have Phantom Power available on the entire set of inputs (on one switch).
You may need to turn Phantom Power on for a single condenser mic plugged into one channel, while plain old dynamic mics are plugged into the rest. It doesn't "hurt" the other mics. It just basically is "there waiting to be used" and then when you plug in something that needs it - like a condenser mic - it "draws" from the power.
However, you should be aware that you do not need to use the XLR.
If you want to used balanced cables in a studio setup, if your mixer's 1/4" inputs accept balanced or unbalanced signals (sometimes says "bal or unbal" on the jack, if not check the manual) you should plug them in directly there instead of the XLR ports.
The XLR jacks are "Mic level" and go through a pre-amp.
The 1/4" jacks are "Line Level (which is what the keyboard is) and do not go through the pre-amps.
The 1/4" inputs also do not send the phantom power so it's not even an issue. So the "right" way to do it wouldn't even cause the question!
Now, if you're on stage and running the Fantom into a Direct Box then a long XLR run to the console (which is the way to do it) you should be using a *passive* DI which doesn't require phantom power.
Not sure what you're using the active DIs for in your setup???