Fantom-S and Fantom-X

How to turn on effects in Performance mode

How to turn on effects in Performance mode

29 Nov 2011, 22:47
On Fan X6
Just trying out Performance mode for 1st time.
Got a 2 part performance set up , with GM sounds #79 Finger Bass, and #11 Elec piano.

Cannot get chorus and reverb to work on elec piano layer.
Went to Performance layer page, part mode page, turned up both effects....but not working.
Page shows effects set at about 1/2 way.. also shows on mixer page ...knobs turned up 1/2 way
Tried various MFX, A, B, 1-4, etc in Out column....but effects not sounding within patch.

Chorus and reverb work fine on all patches within sequencer mode, etc.
What am I doing wrong within Performance Mode?
Any help, greatly appreciated.
BudX6

Re: How to turn on effects in Performance mode

30 Nov 2011, 08:02
Hi Bud,

If you want to carry the effect settings across to the Performance from the original Patches you can (up to a max of three). In the Performance Effects Routing page make sure that the MFX SRC boxes show the "P " of the Part you have the relevant Patch assigned to.

Oh, I know it's obvious, but if you go to the MFX Switch from the Routing page, you have got chorus & reverb turned on?

Hope this helps.
Andy
Andy

Re: How to turn on effects in Performance mode

30 Nov 2011, 08:47
Also, Bud, make sure that the parts that your bass and piano are assigned to are routed to the chorus effect.

← Back to Fantom-S and Fantom-X