Setting Loop Region

8 Aug 2010, 17:57

I'm editing a sample and can't figure out how to save the sample so that it loops. I'm able to set the loop region but can't figure out how to get the sample to play the loop after I save it. Do I have to re-encode it first and then save? The manual makes it sound like all you have to do is set the beginning and end of the region.

Re: Setting Loop Region

9 Aug 2010, 01:09

After you set the beginning and end of the loop, then save the sample, you choose this sample in the oscillator and activate the LOOP switch in the main oscillator screen.

Re: Setting Loop Region

9 Aug 2010, 07:47

Hi webdata,

Im not sure u need this, but dont forget to' Truncate' after u set the begining and end of ur loop. It wil keep the sound u want! (that is the sound in between the loop region. All thats outside will be deleted.)
THen u save it, put it in an oscillator and put Loop on.

Good luck

Re: Setting Loop Region

9 Aug 2010, 20:00

Thank you for the responses. I have yet to try it again. I guess I was a little confused by the loop button that is displayed under the "edit" tab (of the sample editing screen) and the loop button that is displayed under the forward loop tab. I think I tried the loop button under the oscillator screen and it looped then entire sample--not the loop region I selected.

I'll have at it tomorrow. Thank you.

DaMonkster: I didn't see anything about how to trunicate. This might be what I'm forgetting. Is that under the sample edit screens?