Fantom-S and Fantom-X

How to set Vibrato effect on Dbeam

How to set Vibrato effect on Dbeam

31 Dec 2009, 13:03
Hi..is there a way to set D beam so it triggers a vibrato effect on the organ sounds so that the effect swells as it does when you move the controller.

I want to be able to trigger the dbeam and the vibrato comes on AND stays on til I trigger the Dbeam to shut it off.

So far, it only works while my hand is hovering over the dbeam. the moment i take my hand away the vibrato stops. very frustrating..

thanks,

SemiTone
Roland Fantom x8 w/ SRX Complete Piano
Roland FP2 Stage Piano
Korg Triton Le w/ Sampler Expansion
Korg X5D Rack
Kurzweil SP76 Stage Piano
Yamaha YPG-535
Casio Privia 320
Hammond 1970
Acoustic Spinet Mason Rische 1955

Re: How to set Vibrato effect on Dbeam

31 Dec 2009, 13:21
The D-beam cannot work in on/off (latch) mode, so it will only change the effect when you keep hovering your hand over it.

Re: How to set Vibrato effect on Dbeam

2 Jan 2010, 05:28
I'm not sure, just because I never use the d-beam, but if you can use it to activate an RPS, then I think you can set a midi msg on one RPS track that activates the vib.
According to what Art has said on his last msg, the D-Beam cannot be used as an on/off latch mode, so I guess RPS triggering would be a problem too.
You should wait for Artemiy or someone who knows a little bit more about it than I am.
Carpe Diem,
Freifeld Royi

Re: How to set Vibrato effect on Dbeam

2 Jan 2010, 12:32
SonicMan, you are right that you can use the D-Beam to trigger an RPS pattern and this is the workaround for SemiGTone. In Lazeeboy's 3rd post on this page he explains how to use that to run a series of patterns by setting the D-Beam to trigger a pad and then change the assigned pad.

So, in your case, SemiTone, you would have 2 patterns assigned to say pads 1 and 2. The d-beam would be set to pad 1 which would turn on vibrato and set the d-beam to trigger pad 2. So if you hit the d-beam it would trigger that first pad. Then if you hit the d-beam again it would trigger the RPS pattern on Pad 2 which would turn off the vibrato and set d-beam trigger to Pad 1.

Re: How to set Vibrato effect on Dbeam

3 Jul 2010, 22:18
RPS has a param to set the the RPS to continue plaing. Loop1 / Loop2. Check that out.
Ok!!!!!....Now i have all the equipment....if i can just learn to play them.

Re: How to set Vibrato effect on Dbeam

4 Jul 2010, 15:26
eltonafrodziac, how would that help?

← Back to Fantom-S and Fantom-X