2/21/09
Fantom X8 Aftertouch Attitude Adjustment
0. Buy a package kit of self-stick velcro (Fig 1), 1/2" wide by 5 foot length from your local hardware or craft store for $5.99 (we will only be using the self-adhesive felt part, and not the hook part). Cut the 1/2" felt strip lengthwise in half (or buy 1/4" wide stuff if you can find it).
1. Unplug all cables and power, and flip unit over (2) and remove 20 PAN WASHER HEAD TAPTITE B screws and 2 PAN HEAD screws (one from the notch on the left end in the front casing panel, the other in the wood near the front on the right end of the keybed). No need to remove any screws from the aluminum end caps.
2. Flip the unit back over and carefully lift the whole top panel assembly up at the front. Note the ribbon cables connecting the top panel to the keyboard action, and mark them with an orientation mark before removing (3).
3. Set the top aside (4), and work on the keybed assembly (5). The aftertouch pressure strip is on top of the middle rail (6, 7, 8); the front rail is simply a key-stop rail. Compare this to a Kurzweil 2600XS keybed (7a), where the aftertouch pressure strip is acually located at the front of the keys, which is probably why the kurz aftertouch is more responsive. You can check the response of the aftertouch strip by connecting an ohm-meter to pins 1 and 2 (pins 1 and 3 are the same) and pressing on any key (9, 10).
4. Caution! Damage could occur to the keys in this step if you are not careful! If you are unsure at this point, re-assemble the keyboard, or contact Roland technical support for more detailed instructions about removing and installing keys. Start by releasing the keys from their hinge-points at the rear of the keybed (I used a flat file with a handle (11) that was just the right angle to spread the 2 edges of the key enough to release the key when gently pulled up at the back of the key; you could also make your own tool from a piece of wood).
5. Remove 1 octave of keys or so at a time (12) and set them on a flat surface, keeping them in order (13). Once they're all removed (15), you have access to the pressure strip that controls aftertouch (16).
6. Take the velcro felt strip (17) and peel the backing off at one end, press it onto the existing felt (18, 18a). Trim any excess off at the other end (19).
7. Check the key-dip with a dip block, especially if you use a thicker material (20).
8. Now begin the re-assembly: place the front of the keys over the guide (21), the hooks under the pressure rail (6, 7), and carefully snap the rear of each key back onto the hinge at the rear (22, 23).
9. Check the action of every key to ensure that it is working correctly, and check the function of the aftertouch pressure strip - it should take much less pressure on the keys to see the resistance change (8, 9).
10. Place the top panel back on, reconnect the ribbon cables (3), and screw in several of the pan washer srews to hold the top on before flipping the unit over to finish replacing the remaining screws (2).
11. Done (24). Enjoy!