Studio Zone

Micro BR & PSA adapter

Micro BR & PSA adapter

2 Jan 2008, 11:06
I recently purchased a used Micro BR as well as a used PSA adapter to go along with it. While the unit works fine on batteries, it does not run off the PSA adapter. I checked the PSA with a voltmeter and it is indeed delivering 9.6V.

Since the unit is second-hand, I assume that I have no warranty coverage. Any suggestions about what I might do myself to get the DC input to work?

Re: Micro BR & PSA adapter

21 Jan 2008, 15:28
Yes, the PSA adapter is made by Boss, so the polarity I assume to be correct. As I mentioned, the unit works fine on batteries and the PSA adapter seems to be putting out the proper voltage when hooked up to my multimeter. I assume the problem is in the input jack or where it connects to the board, but I'm hesitant to pop the unit open.

Re: Micro BR & PSA adapter

22 Jan 2008, 09:45
Oh I see. Can't you try another PSA or other adapter before opening the Micro? I would advise you to do that, maybe its just the plug that is damaged altough it does not seem so.

I'm very curious to see how is the circuit for Micro BR, must be extremely complex. :)

-----------------------
Boss Micro BR Community

Re: Micro BR & PSA adapter

2 Mar 2008, 15:01
An update to the saga . . . I finally went to Guitar Center with my Micro BR in hand and asked a friendly tech if I could check out my unit by using one of their PSA adapters. Sure enough, their PSA failed to power my unit as well. Therefore, the problem is with the AC input jack of my Micro BR. Again, for fear of opening the thing up, I'll limp along with rechargeable batteries for the moment. My dad works with electronics and may take a look (he suspects a diode issue) when I next see him.

Anyway, now that I have the rechargeables, I've finally been playing with the unit and am really liking it. I picked up a cheap Sandisk SD 1 GB card (at Rite-Aid) and it works just fine.

← Back to Studio Zone