Hi David
Thanks for your reply. Good diagnosis, I would agree that it is probably the caps. Be careful with the type of capacitors that you replace them with.
With sound gear it is not only the capacitance that must be the same but also the dielectric material. If you replace a tantalum cap with an electrolytic you will change the characteristics of the circuit due to vast differences in the ESR (equivalent series resistance) that can occur between capacitor types. This effectively changes the characteristic of any filter causing it to let through frequencies that the designers were trying to remove like mains hum (100-120Hz buzz that you often hear in cheap mains driven kit).
Electrolytics are typically very leaky (good enough for smoothing power supplies where their leaky characteristics are sometimes favoured), but they suck for filters. I have often seen hobbyists replace some fancy super low ESR tantalum cap with a cheap electrolytic that really might as well not even be there because its characteristics are so bad. I mention electrolytic because they (along with ceramic caps) are the easiest to come by in hobby shops but neither are any good for audio filters
I am not sure how to access the main board. I removed all of the screws for the back panel but the panel remained firmly attached. I did not want to risk breaking anything so just put everything back. I was hoping that if someone had schematics then they probably had some form of disassembly instructions as well. There are probably screws on the underside that need to be removed as well, I don't know, but I will need to get someone to help me turn the piano upside down if that is how one needs to get access.
The reason that I went for a ground fault is that certain columns of buttons do not work whereas others do. This is only since I sent it in, so I am sure that it is some bad soldering or cracked tracks or something in that league.
Best regards
Jeremy
The Juno-G comes with fully integrated mind bending. Mind boggling effects are also included for first time buyers. Roland has promised an SRX-Coffee/Cocktail maker interface that works through the USB port in the not too distant future. Roland knows how thirsty musicians get.