Studio Zone

VS1680 Getting the recording off the machine

VS1680 Getting the recording off the machine

7 Oct 2006, 12:55
Hi everyone,
Anyone out there with knowledge of the VS1680 16-track hard disk recorder? I'm confused how I can transfer a multitrack recording from the VS to my computer. I know I should be able to do it analogue (i.e replay the recording with each track routed to an output) but is there a way to do it digitally? The SCSI connection (as far as I can make out from the manual) will accept an external hard drive or CD (does this HAVE to be a Roland CD? or will any make do?) but only for 'backing up' recordings or creating a master CD. What I would like to do is create a disk that can be up-loaded into something like Cubase etc.
is this possible?
Any help gratefully received.
Regards
Keyboard Koo

Re: VS1680 Getting the recording off the machine

22 Dec 2007, 23:24
I have the same question.

I do have the CD burner. However, I wanted to connect the VS1680 directly to the computer. Is that possible?

Thanks...

Getting the recording off the machine

23 Dec 2007, 14:08
Hi,
I wrote this question orginally. Since then I have managed to make it happen by buying an external Plextor Plexwriter SCSI CD machine. Not too bad from Ebay. I can't remember the exact model number anymore and since I've lent it to someone, I can't look to see which one it was. However, somewhere on this forum there is a list of suitable cd writers. It took a couple of visits getting the right cable but that was probably more because I didn't know what I was doing. I can now back-up the recordings or mix them down into 2 stereo tracks and burn them to the cd. However, you cannot, in any way, transfer the data into a computer based recording programme such as Cubase or such. The only way I can do that is by re-recording the signal as analogue via my interface into the computer.
The back-up procedure takes an awfully long time. Be prepared for that.
Hope this helps.

Koo Janzen

Re: VS1680 Getting the recording off the machine

24 Dec 2007, 00:38
I wish we could work with the VS1680 through a computer. It would be much easier to operate.
I think the best way is to burn CDs with each recorded track and then rip it from the computer. I am afraid of losing quality by tranfering it analogicaly.

Thanks,

Lucas M.

← Back to Studio Zone