How to save my REAL TIME CONTROL settings in a patchs

25 Feb 2007, 10:42

How must I saved them?
I saved them on my card, but the patch is the same as it was before I set the settings......

greetings,

rob

Re: How to save my REAL TIME CONTROL settings in a patchs

25 Feb 2007, 11:24

Realtime controls are intended for... uhm... realtime control, e.g. changes to the sound which do not affect the internal patch parameters. If you want to change the patch parameters, go to patch edit mode. Also, if you use the patch as part of a performance, the states of the 4 realtime knobs in filter/envelop mode is saved there.

Re: How to save my REAL TIME CONTROL settings in a patchs

8 May 2007, 14:17

I kind of think this is a shame because it is so much more tedious and hit-and-miss to have to go into the Patch Edit section and find the right thing and then change it for each part, etc.

Or am I making it harder than it is?

Re: How to save my REAL TIME CONTROL settings in a patchs

8 May 2007, 14:52

Or am I making it harder than it is?

Yes you are

In each of the patch edit screens, the 4 knobs are automatically mapped to the most critical parameters: these parameters are marked accordingly with numbers 1..4 on the screen.

Re: How to save my REAL TIME CONTROL settings in a patchs

8 May 2007, 15:03

I figured I was. However, don't you have to make the same change to each of the parts in a patch?

(I should probably not ask questions when I am not sitting at the keyboard.)