Fantom-S and Fantom-X

Patch sounds wrong in Performance mode

Patch sounds wrong in Performance mode

2 Feb 2007, 00:58
I read the FAQ, but it did not help me get the sound right. The patch sounds a lot duller in Performance than in the original. I have the same MFX setting copied over (Tape delay). I even copied it to two adjacent channels on the Mix board and one sounds duller than the other. What should I be looking at?

It's like there are some "old" settings in the channel or something.

Thanks.

howdy R38!

2 Feb 2007, 20:41
Try this...... if you have "x" patch on track 3, press the "effects" button, and make sure the PART field says "3". Below that you'll see A "MFX" field....set this to whatever...we'll say 1....you should see "MFX SRC" AND "REV SRC & CHO SRC" in the same screen. The "SRC" means the source for the particular effect.... So set "MFX 1 SRC" to P3(that's the track of patch "x")...do the same with REV & CHO SRC. Now the chorus, reverb, and fx bank 1 will be set to the "patch mode" fx, chorus, AND reverb settings, so it should sound like it does in patch mode!! hope that helped :) P.S. if that doesn't work, try pressing SONG EDIT, then F4(song utility), and clear the song to start from scratch. Then try the above ;-}

Re: Patch sounds wrong in Performance mode

8 Feb 2007, 14:13
Hi Spishak,

Thanks - you were right. It was in the MFX. Thought I was going crazy there for a sec...

Re: Patch sounds wrong in Performance mode

4 Jul 2007, 10:05
I had the same problem but it was that each track in the Mixer can have the Cutoff set differently (who knew). What I needed to do was to go to the second set of mixer screens. Then, there is a button which shows the default settings of Cutoff and Resonance for each particular patch in that mixer setup.

You can then edit the Cutoff so that it is at +63 (i.e., no cutting off).

← Back to Fantom-S and Fantom-X