Tuomas Easton

Also, it's not 1994 so that's a really ridiculous way to do that.. There are VSTs and macros that you can use to map out a sound to the relative pitch on each key.. instead of spending 90000 hours making 88 different fil...

I just got the Ax-09 Lucina, which seems like just a smaller version of the new full-sized AX synth. I don't think there is a way to switch between on-board sounds and midi, at least not without some other form of contro...

hey all, I just acquired the Roland Ax-09 (lucina), and I can't figure out how to assign midi-channel changes to any of the on-board buttons. Following the manual instructions, I can change the midi channel output by: ho...

Sonata Arctica is 'too hardcore'?! that dude is amazing! I have a few customized keytars. I found it's best to use a light-grit sand paper on the plastic, then a clear-primer (they make them from plastic specifically) wh...

My Ax-7 has patch up/down buttons on the neck, which I just set to solo respective midi channels, I'm not entirely sure how the new AXsynth works, but I know it's much less MIDI-oriented than the previous models of the s...

I have the Ax-7, and I've replaced the ribbon twice, each time because it would fail to return to the correct pitch. It got a little better the last time, but still not completely fixed.. The repair shop eventually told...

yup, This is how I have my live-setup configured. I use a Roland Ax-7 keytar with a Midijet Pro wirless MIDI transmitter. This goes into my Tascam 1800 MIDI interface into my laptop. I run REAPER as my live DAW, and have...

I have used the MidiJetPro for about a year now, and I have never had any problems with it. The range is amazing (we tested at practice, and I walked about 2 blocks away from the house and it was still receiving in real...

Here are some helpful links for MIDI beginners. http://www.youtube.com/watch?feature=player_embedded&v=k0PNubzV9I8 http://tweakheadz.com/how-to-get-started-with-midi-and-the-difference-between-midi-and-audio-is-explained...

I have the Ax-7 and have had this same problem for a while now. I took it to get repaired, $300 later.. he replaced the ribbon, and the problem still didn't go away.. He then said it's probably something to do with the r...