JnC

I think you're correct Gil. I studied the diagram on p.31 of the manual and I think I understand the mod sync routing better. Where I was getting confused is that a higher pitch has a higher frequency. If the frequency i...

I just saw your pictures on your blog. If they don't cover it under warranty, are there any circuit traces that would prevent you from drilling two new holes thru the board and mod hinge? If there's no chance of shorting...

A few suggestions for a firmware update: 1. Remove the monophonic crippling when the oscillators are in sync modulation. 2. Programmable arps. If not possible to do on the keyboard, then at least enable it in the editor....

Contrary to the diagram on the SH-01, I believe OSC1 modulates OSC2. When in sync mode, the pitch control of OSC1 will affect the restart period of OSC2. This control needs to be set at a higher value than OSC2's pitch f...