Help Bulk Load syx file on D-50
16 May 2019, 11:46Help! I can't get Bulk Load to work.
My setup:
PND50-00.syx from bobbyblues
MIDI-OX and D-50 Librarian
USB20Midi USB to Midi interface
PC Win7 Pro with conventional quad processor....nothing fancy.
Connection: USB20Midi from PC's USB port to the USB20Midi and the Midi "OUT" connector to the D-50 midi "IN"
The software seems to send the data without issue. Shows complete when done.
The USB20MIDI "OUT" LED shows output traffic when transmitting
D-50 settings:
Protection: OFF
MIDI Channel 1
Omni: On
Control: B CH
SepCH: 13
Local: ON
Prog.C: ON
Exclu: ON
When I hold down the TRANSFER button throughout the process, the D-50 display changes - showing [Bulk Load.0] instead of [Bulk Load]. The letter "O" in LOAD is replaced with 4 small horizontal lines that together make the shape of the letter "O".
Multiple attempts and settings all produce: MIDI Communication Error
If I change the D-50 MIDI channel, I just get the "WAITING" message during dump.
I tried different values in the MIDI-OX Sysex SEND Configure screen (or D-50 Librarian). Little or no effect.....just ends up MIDI Communication Error on the D-50.
And that's where I am. I went back and tried the different configuration settings in the MIDI-OX (or D-50 Librarian)....to random values and everything comes up MIDI Communication Error.
Any thoughts?
Thanks,
Jim
My setup:
PND50-00.syx from bobbyblues
MIDI-OX and D-50 Librarian
USB20Midi USB to Midi interface
PC Win7 Pro with conventional quad processor....nothing fancy.
Connection: USB20Midi from PC's USB port to the USB20Midi and the Midi "OUT" connector to the D-50 midi "IN"
The software seems to send the data without issue. Shows complete when done.
The USB20MIDI "OUT" LED shows output traffic when transmitting
D-50 settings:
Protection: OFF
MIDI Channel 1
Omni: On
Control: B CH
SepCH: 13
Local: ON
Prog.C: ON
Exclu: ON
When I hold down the TRANSFER button throughout the process, the D-50 display changes - showing [Bulk Load.0] instead of [Bulk Load]. The letter "O" in LOAD is replaced with 4 small horizontal lines that together make the shape of the letter "O".
Multiple attempts and settings all produce: MIDI Communication Error
If I change the D-50 MIDI channel, I just get the "WAITING" message during dump.
I tried different values in the MIDI-OX Sysex SEND Configure screen (or D-50 Librarian). Little or no effect.....just ends up MIDI Communication Error on the D-50.
And that's where I am. I went back and tried the different configuration settings in the MIDI-OX (or D-50 Librarian)....to random values and everything comes up MIDI Communication Error.
Any thoughts?
Thanks,
Jim