Need help loading Expansion EXP Pack 02

Did you unzip the file you downloaded from the Roland site?

Did you wait some minutes?

EXP02.bin is what I have on the memory stick currently. Do I need to change this ? thanks for the quick help this Saturday morning !

Perhaps the file or the USB stick could be corrupt. Try downloading and unzipping again, and try a different USB stick if you can.

this is starting to bug me now. When it (video) calls for me to press Pad 1, nothing happens. USB is in the slot, my screen reads ==Wave Update Mode==
[SLOT1:-------------]
[SLOT2:-------------]

Please select a file for SLOT 1.
(PAD:1-16. EXIT:Remain):

Pads are illuminated, I go to press Pad 1, nothing happens on the screen. Tried 3 sticks, all do the same thing. The file on the stick has been extracted (unzipped), went through power down pressing Preview, get the above on screen. Go to PAD 1, everything stops. Good grief. I have never used the Pads yet for anything. is there some internal way of activating them (other than they are illuminated) that I haven't done ? After pressing PAD 1, I get Error !! (ENTER: Retry): Thanks !

Found my problem. Had to change the .bin file saved on the computer to EXP02.bin and save to USB stick, did the same procedure, loading now. phew !

now another question. I really like the EX02 # 0116 B3Sermon SRV, it has the V3/C3 slow rotor emulation tone like my old B3 and Leslie 122. Can I save this particular PCMS tone to a Studio Set List which I want to try making now, to bring it up and save for live playing ? Thanks !

yes, you can save the tone in any studio set. But you have to keep the EXP loaded in your FA, otherwise the tone will be not accessable.
You cannot save PCMS 'data' (that means waveforms) to internal RAM. It will always stay in the virtual EXP board.

Perfect. I don't think I will need any more tones now with all that are available on the FA-06 and EXP-02. Now to figure out what I want to create in Studio Sets, definitely including some from the EXP-02. Wow, lots to create with. On a good learning curve with the FA-06. Thanks very much for the help !

fa06roland wrote:

Found my problem. Had to change the .bin file saved on the computer to EXP02.bin and save to USB stick, did the same procedure, loading now. phew !

How did you do it im having that same problem

Just do what Ed Diaz does in the support video below.

https://www.youtube.com/watch?v=frjNwUtqXCw