MC-808

Loading patches with the editor

Loading patches with the editor

6 Jun 2007, 07:28
Hi folks,

if i have a pattern with assigned patches in the editor software, save it to a *.mc8 file and later load it back into the mc-808: Will the patches at the original patch number be overwritten?

Anyone any experience here?

Thanks alot,

Dirk.

Re: Loading patches with the editor

6 Jun 2007, 13:05
basically the changes to patches are written to a temporary buffer, which means you can hear the changed/edited patch until you switch the unit off, at which point all edit buffers are reset.

if you look at the MicroScreen (TOTAL dubbed it so %) ) after doing some edits to the patch you should see an asterisk (*) mark before the patch name, which means the patch was edited, but was not saved.

to save the patch permanently, you must manually write it to the desired bank-patch slot.

i had not found any info on how many edit buffers does 808 have, but assuming this is a serious groovebox, there should be at least 16 edit buffers available to tweak all the parts in a pattern.

so when you load an *.mc8 file the changes are written to temporary edit buffers, and if you wish to save changes, you must manually write them.

i did test this with a single part/patch, but i assume it should be safe to use all 16 parts as well.

hope this helps.

← Back to MC-808